What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 03.07.2025 03:19

But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
but this device (an Inductor) … impedes the rapid changes in the current.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
This is 'the assistant's answer'
This device then solves the entire problem.
First Sentence:
Colorado has now recorded 10 measles cases this year as airport outbreak grows - GazetteXtra
The third is lightning and “how it gets conducted into a home.”
the problem then depends on "how fast does the fuse operate?".
In schematic diagrams this is the symbol for a fuse:
NASCAR hopeful for deserved return to Mexico City in 2026; will INDYCAR join? - FOX Sports
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
It also is a device that limits the change in current flow.
An Optometrist Is Begging People To Stop This Common Habit ASAP - AOL.com
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
This one hit behind the barn.
New study uncovers surprising physics of 'marine snow' - Phys.org
At one ohm, the resistor has a maximum of 1 watt power.
Here is a simplified AC power diagram.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Upvotes:
But… the neutral is now “floating” because of the 1 ohm resistance.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
What's your wildest & weirdest fantasy?
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
(Dc diagram shown, AC is similar).
Because the load is inductive, the current lags the voltage.(by a bit).
What is lightning?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
What does a fuse do?
Why do almost all vertebrates have tails, but not apes and frogs?
2024–10–10[John johnson John Johnson ]
It seems Mohan does not understand the difference between a comment and an Answer.
This is where this question deviates from being a 'generic' question, and becomes more specific.
"Can't Believe Virat Kohli Knew...": RCB's Celebrations Amid Stampede Row Heats Up - NDTV Sports
2024–10–16 [ OO OLAOYE OYEBODE ]
a photo is worth a thousand words.
He then asserts :
Which is the best AI app for house plan making?
but I think this circuit , shows a few more pieces.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
These devices are installed between the “hot” and “neutral” and protective ground.
Elon Musk Says XAI Will Retrain Grok: 'Far Too Much Garbage' - Business Insider
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
so, what happens?
2024–10–14 [Omar Gharbi Omar Gharbi ]
There are three different concepts here that are getting confused.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
One is “what exactly is in a ‘surge protector’ ? ”
An AC voltage/ current source, and an ac inductive load.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
nine
These are simplified answers to the original question, and does not change anything I wrote above.
Edit 2024–10.
The bolt then partially travels down the line to your home.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Barnstars:
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
He then describes the function of a fuse.
[old diagram got deleted by accident]
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
eight
[image of Common-mode choke]
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
The other is “what does a “fuse” do?”
This is where the MOV conducts again, and dissipated the energy.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
A fuse is a non-resetable over current circuit protector.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
One
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Now when you have a certain ac resistance, then a current flows in a loop.
There are two important concepts here.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
He then describes Rainy Season and Lightning.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
But it can get overloaded, and no longer works.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
For this case there are devices called Metal oxide varistors (MOV).
what exactly is a ‘surge’ protector?
The MOV will conduct when the voltage exceeds 50% of line voltage.
So, the voltage could go up to 500 volts, and the fuse will not open up.
I post the exact comment here.
A circuit breaker is similar, but is resettable.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
At least they know the answer if they wanted it.